1. Welcome to 4Runners.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all 4Runner discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other 4Runner owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Rough idle

Discussion in '3rd Gen 4Runners (1996-2002)' started by Danp52000, Apr 2, 2017.

  1. Apr 2, 2017 at 6:20 PM
    #1
    Danp52000

    Danp52000 [OP] New Member

    Joined:
    Apr 2, 2017
    Member:
    #3818
    Messages:
    1
    Vehicle:
    2001 3 runner
    To start water pump and timing belt were shot. Replaced both it now runs rough. Got a code reading stating replace camshaft position sensor did that. Still runs rough and has no acceleration when pedal smashed to the floor. When installing timing belt I made sure that all the marks lined up to the marks on the belt and pulleys. Don't see any hoses loose. I'm at a lose as where to look.
     

Products Discussed in

To Top