1. Welcome to 4Runners.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all 4Runner discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other 4Runner owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Rad Rubber Design engine splash guards

Discussion in '4th Gen 4Runners (2003-2009)' started by Bigcanoe, Aug 1, 2020.

  1. Aug 1, 2020 at 6:26 AM
    #1
    Bigcanoe

    Bigcanoe [OP] New Member

    Joined:
    Jun 18, 2020
    Member:
    #14983
    Messages:
    17
    Gender:
    Male
    First Name:
    Arn
    Vehicle:
    2008 White 4Runner
    I installed a set of these today on my 4th Gen. They were a $58.35 and took a couple of weeks to arrive. I was immediately impressed. They are thick but flexible. They came with clear instructions and a little sticker. The fasteners are also high quality. They are made in the USA. My old guards were totally gone. The scraps that were left were brittle, thin plastic, unlike these rubber replacements. Installation took me about 20 minutes in my driveway. I did use a fastener pulling tool (not included) to remove a few old body fasteners. I am very pleased with the product!

    IMG_4442.jpg
    IMG_4444.jpg
    IMG_4448.jpg
    IMG_4449.jpg
     

Products Discussed in

To Top