1. Welcome to 4Runners.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all 4Runner discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other 4Runner owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Morimoto 4 Banger and Switch Pro

Discussion in 'General 4Runner Talk' started by Mr. Snuffleupagus, Nov 22, 2022.

  1. Nov 22, 2022 at 10:56 AM
    #1
    Mr. Snuffleupagus

    Mr. Snuffleupagus [OP] New Member

    Joined:
    Dec 6, 2021
    Member:
    #24531
    Messages:
    33
    Gender:
    Male
    First Name:
    Brandt
    Vehicle:
    2022 TRD Pro
    I just finished wiring my Switch Pro 9100 panel and power tray system and Im ready to start wiring up some lights. I'll be running a Baja Designs S8 and Morimoto 4 banger A-pillar ditch lights. Baja sells a specific up fitter harness designed to work with the switch pro (no relay) but Morimoto doesn't appear to have any options. The 4 bangers run a DT 2 pin connector like some other brands. The only non-relayed switch I can find is from Diode Dynamics (link below) and the amperage should be well within spec for this harness. I suspect this will work fine with a direct wiring to my Switch Pro but would love advice from anyone who has switch pro wiring harness experience.

    https://www.diodedynamics.com/oem-auxiliary-switch-dual-output-2-pin-wiring-harness.html
     

Products Discussed in

To Top