Leveling kits

If I put a 3” leveling kit on the front and a 1”1/4 leveling kit on the back will I have to make any modifications

 

With 3” up front, maybe. Read through the threads here, plenty of info on 3” lifts.

 

At least a diff drop

 

We put a 3"/2" on ours with the diff. drop in the front. I would love to tell you that the diff drop will stop the needle bearing problem in the front but it won't. Ours was good until right after the 5k mile checkup. The diff drop kit will help CV angles. RevTek kit/ diff drop.

 

Needle bearings in what?And what is the fix for that.Thanks for your reply

 

Think you need to do more reading in the suspension section.

There is tons of info there better than everyone explaining one thing at a time.

 

Was referencing the on going needle bearing problem in the front diff., it was supposed to be "calmed" down by the install of a diff. drop kit, it is taken care of by the dealer. The modifications to your 4Runner when you install a spacer lift are minimal. We installed a 3"/2" RevTek kit, new rear shocks came with the kit, so did the front diff. drop kit. Not sure if you need shocks with only 1.25" rear.

 

Thanks Jeff .I am stil struggling with the tire size for these stock 20” rims I have.Not much info on tire size that I have time to find on here but can I possibly go with 33x12.50 x20’s without trimming and all?

 

Dumb question, but are the lifters here not concerned about not having enough clearance in parking garages? I guess not, but I am sure you must have at some point faced this issue?

 

That's not a dumb question at all. I remember my brother moved to the Bay Area years ago and he had a problem finding parking garages that he could fit in, height wise with his full size chevy conversion van.

You might have to do a little research.