1. Welcome to 4Runners.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all 4Runner discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other 4Runner owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Crankshaft bearing cap numbering

Discussion in '3rd Gen 4Runners (1996-2002)' started by idahiguera, Jul 20, 2017.

  1. Jul 20, 2017 at 10:59 AM
    #1
    idahiguera

    idahiguera [OP] New Member

    Joined:
    Jul 20, 2017
    Member:
    #4418
    Messages:
    4
    Gender:
    Female
    Vehicle:
    2001 toyota 4 runner
    Hi I have a question the top rod bearings caps are the numbered on how they go on
     
  2. Jul 20, 2017 at 11:33 AM
    #2
    Bob

    Bob Member Staff Member

    Joined:
    Apr 3, 2014
    Member:
    #1
    Messages:
    2,243
    First Name:
    Bob
    SoCal
    Stolen from a reference:

    Bearing caps are usually numbered and marked with an arrow facing forward
     
  3. Jul 20, 2017 at 11:43 AM
    #3
    idahiguera

    idahiguera [OP] New Member

    Joined:
    Jul 20, 2017
    Member:
    #4418
    Messages:
    4
    Gender:
    Female
    Vehicle:
    2001 toyota 4 runner
    Ok so 1 mark goes on rod 1 and so on right
     
  4. Jul 20, 2017 at 11:51 AM
    #4
    idahiguera

    idahiguera [OP] New Member

    Joined:
    Jul 20, 2017
    Member:
    #4418
    Messages:
    4
    Gender:
    Female
    Vehicle:
    2001 toyota 4 runner
    Thank you for answering me
     
  5. Jul 26, 2017 at 1:59 AM
    #5
    larramo

    larramo 3ed gen faithfully

    Joined:
    Jul 10, 2017
    Member:
    #4363
    Messages:
    107
    Gender:
    Male
    First Name:
    larry
    clearlake ca
    Vehicle:
    4 runner
    3" lift but mostly all stock not a scratch on it it is pristine condition amazing for being 19 years old.
    also if you are rebuilding your engine have the shop stamp the bottom of the connecting rods so if you sell it and the new owner has it rebuilt they will know that the block has been honed as not to make the cylinder walls too thin.
     

Products Discussed in

To Top