1. Welcome to 4Runners.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all 4Runner discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other 4Runner owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Alternator mount

Discussion in '1st Gen Builds (1984-1989)' started by 1stgenlily, Jan 7, 2023.

  1. Jan 7, 2023 at 11:47 AM
    #1
    1stgenlily

    #1
    1stgenlily [OP] New Member

    Joined:
    Jan 7, 2023
    Member:
    #30483
    Messages:
    1
    Gender:
    Female
    First Name:
    Lily
    Vehicle:
    1986 white 4runner
    engine swap with a 22r
    Hi, I did an engine swap on my 86' 4runner with a 83' 22r engine, my 4runner is fuel injected so I put that air intake on the 83' block. Everything bolted up and matched with the two engines. It has been a few months and my alternator belt keeps wearing wrong so I decided to take the power steering pump off to access everything easier. While doing so I noticed my lower alternator mount seems to be crooked? Im not sure why because it bolts up correctly but it seems to be slightly leaning towards the driver side tire. I dont believe the mount is bent itself because its a pretty solid piece. Is there any way to adjust it to make it straighter? or any other information that could help
     
    1stgenlily, Jan 7, 2023
    #1
Register FREE to Reply!

Products Discussed in

Pro Comp Drag Link - TOY400
$67.89
To Top