1. Welcome to 4Runners.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all 4Runner discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other 4Runner owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

'04 starter cranking hold function issue

Discussion in 'General 4Runner Talk' started by filamb1, Sep 17, 2016.

  1. Sep 17, 2016 at 10:35 AM
    #1
    filamb1

    filamb1 [OP] New Member

    Joined:
    Sep 17, 2016
    Member:
    #2676
    Messages:
    2
    Gender:
    Male
    First Name:
    Scott
    Vehicle:
    2004 SR5 4WD 404,000miles
    2004 SR5 4WD 404,000+ miles replaced engine with a salvage at 365,000 - blow head gasket
    My runner has a starter switch with a cranking hold function. You just hit the key and let go and it will crank for 25 seconds or until started. Well, it was already running the other day and I got distracted by my beautiful wife and tried to crank it again. It just clicked and went dead. In the past when I have done that it didn't do anything and kept running. When I try to restart it now it just clicks and shuts off all the dash lights except the battery light. Even the dome light goes out. When I turn the key off everything resets and I can try again with the same results. I don't appear to have any blown fuses. I have disconnected the battery to see if that would help. It didn't. Is there a relay I am missing? Or have I blown the solenoid?
     
    captsolo likes this.

Products Discussed in

To Top