1. Welcome to 4Runners.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all 4Runner discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other 4Runner owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

P0137

Discussion in '4th Gen 4Runners (2003-2009)' started by JR0080, Nov 23, 2022.

  1. Nov 23, 2022 at 11:57 AM
    #1
    JR0080

    JR0080 [OP] New Member

    Joined:
    Nov 23, 2022
    Member:
    #29756
    Messages:
    1
    Gender:
    Male
    Vehicle:
    2006 4runner v6
    .
     
    Last edited: Nov 28, 2022 at 7:55 AM
  2. Nov 24, 2022 at 8:42 PM
    #2
    negusm

    negusm New Member

    Joined:
    Oct 22, 2019
    Member:
    #11745
    Messages:
    1,294
    Gender:
    Male
    Vehicle:
    2002 4Runner SR5 4WD
    "P0137 is the OBD-II generic code indicating the O2 sensor for bank 1 sensor 2 is failing to increase the voltage output above .21 volts indicating excessive oxygen in the exhaust. This code occurs when the engine control module (ECM) sees the voltage of the O2 sensor for bank 1 sensor 2 below .21 volts when the ECM has commanded the fuel to a targeted rich condition on that bank of the engine."

    Most common culprits seem to be O2 sensor. Exhaust leak. Bad wiring.
     
  3. Nov 25, 2022 at 3:46 PM
    #3
    negusm

    negusm New Member

    Joined:
    Oct 22, 2019
    Member:
    #11745
    Messages:
    1,294
    Gender:
    Male
    Vehicle:
    2002 4Runner SR5 4WD
    I doubt you will get that code to go away unless you put the exhaust system back to stock.

    I don't know how the ECU would figure out how to adjust the fuel mixture with no cats.

    Maybe someone knows more.
     

Products Discussed in

To Top