1. Welcome to 4Runners.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all 4Runner discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other 4Runner owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

High Beam ECT Transmission Issue

Discussion in '3rd Gen 4Runners (1996-2002)' started by Amax, Feb 1, 2025.

  1. Feb 1, 2025 at 1:46 PM
    #1
    Amax

    Amax [OP] New Member

    Joined:
    Feb 1, 2025
    Member:
    #45282
    Messages:
    1
    Gender:
    Male
    Vehicle:
    2000 SR5
    Toytech, bumpers, rack, air freshener
    Posting to help with a bit of an obscure issue. On my son's 2000, when you turned on high beams or ECT it would shift into 1st gear and the reverse light would come on. Totally fine on low beam and without ECT on.

    I doubted his description a bit but sure enough it was 100% repeatable. Threw some shift solenoid and neutral safety switch codes as well. Long story short, its the thin blue flexible PC board behind the dash display that covers the whole back side of the dash display. About $100 from dealer and not a bad job to swap. Good time to upgrade to LEDs because all the bulbs have to be removed anyway. Any of the display LED swap videos show how to get the display out, just common sense and handling the board with care when swapping from there. I know different years are similar but not exactly the same

    All good now.
     
    negusm and roboturner like this.

Products Discussed in

To Top