Stock suspension height

Just installed the eibach stage 1 kit on my 2023 TRD off road and forgot to get measurements of before. After, it’s sitting at 22in in the front and 23 in the rear( measured from center of the hub) or approx 36 in in the front and 38in the rear ( measure from the floor). Does anybody know what the measurements are with stock suspension. I do have KDSS.

 

I saw something on another forum a while back while researching this kit for myself and an owner posted 19" front and 21.5" rear. I'm curious to compare my post-lift measurements with yours now.

 

These were my before and after measurements from an Eibach leveling lift put on in 2020:

Measurements before and after:
Before:
From hub ctr From ground
LF 19.25" 34"
RF 19.50" 34.25"
LR 21.75" 36.50"
RR 21.75" 36.625"

After (with minimum driving/settling):
From hub ctr From ground
LF 20.00" 34.875"
RF 20.50" 35.25"
LR 22" 36.75"
RR 21.75" 36.75"

 

Measure from center of hub to bottom of fender.

ground to center of hub isn’t going to be correct for everyone. And also will change on load inside vehicle and tire pressure

also the front is lighter if it’s a 4x2 compared to a 4x4 vehicle.

 

Stage 1 is spec’d at 2.75” up front and 1” in the rear. I’d expect to see you somewhere between 22” and 22 1/2” up front depending what your measurements were prior.

Lift numbers are based on 20” up front and 22” in the rear.

 

Dobinsons works off of the stock height of
20" Front
22" Rear
*Center of hub to bottom of fender.

As others stated every rig is a little different but this is a good baseline.