Actuator timing

So I have looked thought these threads and many people just give up and buy a new actuator for the TC when it binds up because they cannot figure out the timing. I am in the middle of this saga as I believe my 4Hi Low rod got bound up by the gasket getting sucked into space between the rod and actuator housing (bought it used and never was put in Low )
I think In the top part of the actuator, all the timing lines are set to 4WD high…
The question I have is, what needs lined up in the bottom part of the actuator? Can any one help?
A new one comes from the factory preset in 4WD HI so I assume the lower rod is out ( all the way the TC) but not clear on the gear positions for this? I see a few timing lines on the white gear and really none on the brown gear

 

Welcome and good luck!!

 

Hi, probably to late...
https://www.4runners.com/threads/need-help-with-my-4wd-system.16519/#post-319353

 

I had my own head ache figuring this out. You can do it, and will have to Mark some reference marks of yourself. The attached document will help you figure it out.

See pictures in my thread
https://www.tacomaworld.com/threads/prerunner-to-4x4-conversion-concluded.468300/page-5