What wheel offset and width to fit 285 Cooper Discoverers with little to no rub?

Seen too many threads about this but just want a straight answer. Installing a Billstein 6112/5160 lift. 2.3” front, clip at #7/#5 rear 1.5. OME UCA’s. What wheel offset and width do i need to buy to fit 285 cooper discoverers with little to no rub? 17” wheel in mind.

 

Were you ever able to get an answer for this? I'm attempting a very similar setup with Dobinson IMS 2.5" front 1.75" rear lift. I currently have -12 offset Method 703s.

 

I have the stock pro rims and 285's with no rub at full lock. (3" lift) Now, on my taco it was the same BUT when I went Method's it rubbed and I believe that was the -12 but not 100% on that.

 

Yes i found my setup. Im running SCS 17x8.5 -12 offset. OME uca’s with the caster set to push the wheel a tad bit fwd in the wheel well during my alignment. I had to trim the fwd side of the fender just a bit and push the fender liner out of the way with a hear gun but no body mount rub