1. Welcome to 4Runners.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all 4Runner discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other 4Runner owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Strange Electrical Problem

Discussion in '3rd Gen 4Runners (1996-2002)' started by danielmidkiff, May 26, 2022.

  1. May 26, 2022 at 5:26 AM
    #1
    danielmidkiff

    danielmidkiff [OP] New Member

    Joined:
    May 26, 2022
    Member:
    #27199
    Messages:
    1
    Gender:
    Male
    First Name:
    Daniel
    Vehicle:
    97 Limited 4Runner
    Recently had to downgrade my 4runner from daily driver to recreational because of a head gasket issue (still runs fine - LOL). I drive it maybe once a week or so, mainly around the farm stuff. Hop in the other day and the CD player had ejected the disc, which usually means the battery has been disconnected or low voltage at some point. I also noticed the door locks not wanting to engage. I hear the click under the hood, but the plungers just wiggle a little. When I open the doors the dome lights (LED) come on intermittently. Inserting the key activates the chime, but when I turn the key it stops and sometimes the instrument panel lights up sometimes not. If I turn the key to the "start" position, sometimes I hear a little chatter under the hood, sometimes it cranks with no problem (like it should - strong), other times - nothing - no clicking starter - nothing.

    The starter was rebuilt in the last year and the battery is strong. I've checked my terminals on the top side but have not been underneath. It's been raining every time I've had time to check it out.

    I'm leaning towards a ignition switch problem, but have not worked on one in this vehicle. It seems that there are 2 parts, the lock cylinder and the switch. I'm not sure which would cause this issue if any.

    Anyone have this happen to them?

    97 Limited 3.4 AT 4x4
     
  2. May 26, 2022 at 5:50 AM
    #2
    ZackDanger

    ZackDanger New Member

    Joined:
    Jan 28, 2022
    Member:
    #25387
    Messages:
    34
    Western MA
    The problems you describe made me jump to insufficient or intermittent voltage... either from a bad battery or bad electrical connections. You said you checked the terminals and the battery is strong (including load test?)... so if those are totally ruled out my next guess would be ground wires (from the battery to the chassis) or similar.
     
    2Toys likes this.
  3. May 26, 2022 at 11:21 AM
    #3
    SR5 Limited

    SR5 Limited New Member

    Joined:
    Sep 18, 2018
    Member:
    #7180
    Messages:
    12,327
    Vehicle:
    1996 SR5 Limited
    Does it do the same thing with the spare key?
    My key wore out and started acting up.
    I even sprayed a bunch of WD-40 in the key hole.
    Didn’t seem to effect it in any way.
    But the new key worked and is still working.
     
  4. May 26, 2022 at 10:26 PM
    #4
    PhantomTweak

    PhantomTweak New Member

    Joined:
    Dec 20, 2019
    Member:
    #12402
    Messages:
    1,206
    Gender:
    Male
    First Name:
    Patrick
    OREGON
    Vehicle:
    1999 4Runner, bone stock
    None. Bone Stock. EXCEPT: Brushguard, tow hitch, both welded to the frame. It's good to have friends and a fully equipped garage!
    As far as I know, the Switch portion of the key setup is the only portion of the assembly that can have any effect on the vehicles electrics. If it aint gots a wire, how can it affect the electrical systems? The lock cylinder portion of the set might prevent the switch cylinder from turning properly, thus appearing to affect the vehicle's electrical systems, but again, it's just an appearance, not an actual effect.

    If it were me, before I did anything about the keyswitch replacement, I would pull the assembly out, at least to where it's reachable, and spray the switch portion with electrical contact cleaner. Plenty of cleaner. Until what comes off runs clear when the key is being turned while spraying the switch portion. Remember to place a disposable, but sufficiently heavy, cloth under the switch when spraying to ensure capture of ALL the cleaner that comes off when spraying. Also bear in mind that the cleaner, in some cases, is flammable. Use all flammability precautions, like you would when working on loose, or open, gasoline. Avoid anything that could cause sparks, open flames like a cigarette lighter, and so forth.

    Once it's cleaned out, try it again to see what happens. Make sure it's completely dry of all cleaner before plugging it back in.

    Good luck!
    Pat☺
     
  5. May 27, 2022 at 6:53 AM
    #5
    negusm

    negusm New Member

    Joined:
    Oct 22, 2019
    Member:
    #11745
    Messages:
    1,901
    Gender:
    Male
    Vehicle:
    2002 4Runner SR5 4WD
    Battery cables degrade internally and you won't see it. I've had my 3rd gen and one other car show exactly these symptoms.

    Replacement of the cable or cutting off 12" of the cable to get back to good copper and splicing in a repair fixed things permanently.

    Take your cable terminals off the battery and "abuse" them. If the connector breaks, or if the cable feels like its crinkly when you bend it, the cables are shot.

    To me, this is not an ignition switch issue. Too many other power related issues to be an ignition switch.
     
    Last edited: May 29, 2022
  6. Jun 6, 2022 at 9:50 PM
    #6
    xrevolver

    xrevolver New Member

    Joined:
    Jul 29, 2015
    Member:
    #808
    Messages:
    54
    Gender:
    Male
    First Name:
    Jarred
    GA
    My neighbor recently acquired this 2001 4Runner and it have this intermittent voltage issue. It got a new battery and starter so it got to be the wiring. We'll just finish installing the suspension and american force wheels onto the truck this week before we can clear the garage.
     
  7. Jun 7, 2022 at 10:10 PM
    #7
    Trekker

    Trekker Regular Member

    Joined:
    Jul 25, 2020
    Member:
    #15732
    Messages:
    904
    Gender:
    Male
    Vehicle:
    1997 3rz 5spd
    Check the ground cables, sometimes they can cause strange problems.

    I'm sure you were told this, but don't drive with a bad head gasket if you hope to fix the engine, even if it seems fine
     
    xrevolver likes this.
  8. Jun 9, 2022 at 8:52 PM
    #8
    xrevolver

    xrevolver New Member

    Joined:
    Jul 29, 2015
    Member:
    #808
    Messages:
    54
    Gender:
    Male
    First Name:
    Jarred
    GA
    Ground cable is on top of the list. He's deciding to replace the battery cable.
     

Products Discussed in

To Top