help diag 04 tr4r starting after fuel pump install

With a start like this; I know I am in the correct spot.
2004 Toyota 4runner limited v8 4.7 (2UZ-FE) 4wd
turned 200K (Original Owner)


Huge issue goes like this: Not once did I have a issue with my 04
and then it turned 200K, while driving down hwy 75 in Dallas TX It started to stall. well the
fuel pump gave in, of course I had a fully loaded landscaping trailer attached, barely made it to
a Walmart parking lot.
changed it in the parking lot, of course buying their cheep deep socket set. Cranked it up after a 3 hour
process and drive approximately 1.5 miles towards home and it stalled again barely making it to another
parking lot. Whereby leaving it for 2 days. I then towed it to my storage unit and it is still there 2 months later.

1. Change the fuel pump again thinking it was defective.
2. Then I had crank no start.
3. Ran all the usual check list items that I read about.
4. Found the mystery (no power) to the fuel pump
5 Change all fuses/relay's relate to fuel delivery

Caveat :
pour gas in the throttle body runs as normal. when gas runs out the it dies, however on some occasions it will run on its own.

I am stumped by this image. Purchased the Techstream mini vc cable loaded to my laptop and ran live tests.
this is the result

can someone point me in the right direction. what would cause everything is set to the off position.
I can run the turn on status of each off position. reset the ecu along with saving diag. I am blonde yet not that stupid, but I need real help. my wife thanks you in advance.

 

Did you find out what the issue was? Because I have the same truck and it did the same. Thanks in advance

 

In my case, it turned out that I spun a bearing. Had my engine rebuilt not on road yet.

 

However I found out related to the fuel issue, is that the sending unit arm was no longer sending the correct signal to maintain fuel pressure. Thus the sending unit microchip went bad. This took me a bunch of time to figure out.