1. Welcome to 4Runners.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all 4Runner discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other 4Runner owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Replacing fuel filter 3rd gen 4Runners **PICTURES**

Discussion in '3rd Gen 4Runners (1996-2002)' started by ramonortiz55, Jun 29, 2015.

  1. Jun 29, 2015 at 4:06 PM
    #1
    ramonortiz55

    ramonortiz55 [OP] New Member

    Joined:
    May 3, 2015
    Member:
    #590
    Messages:
    1,665
    Gender:
    Male
    First Name:
    Ramon
    Vehicle:
    2001 4runner limited silver millenium
    So today I was able to do some maintenance work on the 4runner. I decided to replace the air filter, fuel filter and PCV valve.

    air filter and PCV valve replacement are straight forward.

    Went ahead and did a write up for replacing the fuel filter on a 3rd gen 4runner.

    Relieve fuel pressure by opening fuel door and gas cap and leave open for about 20 minutes.

    The fuel filter is located on the driver's side of the 4runner, in the area of the driver's door.

    Taking a peek below, there will be a dust shield. Remove the dust shield.

    [​IMG]

    [​IMG]

    Once the dust shield has been removed, this will reveal the fuel filter:

    [​IMG]

    The fuel filter would have to be removed by loosening two flare nuts: one on each end.

    [​IMG]

    Once these are loosened, remove two nuts holding the fuel filter and carefully pull out the fuel lines, one side at a time. At this moment you should be able to pull the fuel filter and fuel filter bracket assembly off the bottom of the 4runner.

    [​IMG]

    [​IMG]

    Comparing both new and used filters:

    [​IMG]

    Install is reverse of removal.

    I would suggest, install the flare nuts FIRST. The flared fuel lines need to sit in the filter perfectly straight to make sure it doesn't leak. Once the flare nuts are tightened, turn on the 4runner and check for leaks.

    If no leaks are present, install the nuts that hold the fuel filter bracket to the bottom of the 4runner and dust shield.
     
    ThorInc and Bob like this.
  2. Jul 1, 2015 at 7:00 PM
    #2
    Ol'Blue

    Ol'Blue New Member

    Joined:
    Apr 12, 2014
    Member:
    #55
    Messages:
    1,376
    Gender:
    Male
    "Not all who wander are lost"
    Vehicle:
    99 T4R LTD- 33's and locked, 01 SR5-,SAS Sold...
    A few things here and there. Still dreaming up stuff
    Holy hell. You still have a dust shield on your 4runner....
     
    W3LCH and ThorInc like this.
  3. Jul 2, 2015 at 5:44 PM
    #3
    ramonortiz55

    ramonortiz55 [OP] New Member

    Joined:
    May 3, 2015
    Member:
    #590
    Messages:
    1,665
    Gender:
    Male
    First Name:
    Ramon
    Vehicle:
    2001 4runner limited silver millenium
    It's ripped, and it bothers me. Need a new one lol
     

Products Discussed in

To Top