1. Welcome to 4Runners.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all 4Runner discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other 4Runner owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

98 JDM Engine Swap wont start

Discussion in '3rd Gen 4Runners (1996-2002)' started by GHO5T5NIPER, Sep 16, 2014.

  1. Sep 16, 2014 at 4:08 PM
    #1
    GHO5T5NIPER

    GHO5T5NIPER [OP] New Member

    Joined:
    Sep 16, 2014
    Member:
    #267
    Messages:
    2
    Gender:
    Male
    First Name:
    Evan
    Vehicle:
    1998 4Runner Limited
    Hey guys I drove through some questionably deep water about a year ago and threw a rod in my 240k mile 1998 5vzfe. For the last year we have been working on it and we bought a JDM engine with said to be low mileage. Put everything together and finally tried to start it last night and the relays all seemed to click but the starter made no noise at all. It is a brand new starter. Battery is good. All the grounds are where they are suppose to be. We can hear clicking coming from a relay near the battery and a relay on the passenger side. Could this be Neutral Safety Switch? If so how do you get to it and check and see if its good? What else could it be? Does have aftermarket clifford alarm system. Thanks in advance!
     
  2. Sep 17, 2014 at 1:42 AM
    #2
    Utah

    Utah Misanthrope

    Joined:
    Jul 31, 2014
    Member:
    #213
    Messages:
    194
    First Name:
    Kevin
    Land of Fake Beer
    Vehicle:
    The Gray Bastard
    3RZ, OME, 5.29s, 4.7, locked/locked
    Run a jumper wire from the positive battery post to the starter solenoid. If the starter and solenoid are good, this will crank the motor, so don't have your hair hanging in the radiator fan or anything. If that works and the motor cranks, get out your wiring diagram and find where the ignition wire comes from (likely the fuse box). Keep stepping back like that until you find power, and you'll find the problem. It might be worth deleting that alarm and returning the wiring to factory until you get the problem figured out.

    I have an FSM in pdf I can share with you, but it's not indexed and nearly worthless. I recommend springing for a 2 day Alldata subscription and spending a couple hours downloading and printing everything you can.
     
  3. Sep 17, 2014 at 6:12 AM
    #3
    GHO5T5NIPER

    GHO5T5NIPER [OP] New Member

    Joined:
    Sep 16, 2014
    Member:
    #267
    Messages:
    2
    Gender:
    Male
    First Name:
    Evan
    Vehicle:
    1998 4Runner Limited
    Hanks for the reply! We connected the two ends on the starter by continuing the circuit through a screw driver and the motor did crank. Tested the ignition wire on the starter and it's not getting any power when key is turned so it makes me think either alarm system or neutral safety switch. I'm leaning more toward the alarm system. All I know about it is it's a Clifford WM-5000V5 but my google search didn't really turn up with anything. Everything pictured looks a lot newer than the one on my car. Did a couple of alarm system bypass techniques with no luck.
     

Products Discussed in

To Top