Trident904’s 22 TRD OR Premium on 35’s

Amen. and

 

https://youtu.be/Y0c74TTGdeg

 

Patterson Gap Rd to Coleman River Road was fun and has some offshoots that need exploring.

https://youtu.be/1haBIvAXpro

 

If anyone was wondering, the S&B intake works with a snorkel.

 

Ordered the AFE catback exhaust today.

 

Following. Interested in how this exhaust sounds on a 4runner.

 

I’ll post up a sound clip when it gets here and I get it installed.

 

AFE exhaust installed. It’s not too loud and not too quiet. Sounds good and no drone at all.

Hopefully the video captures it okay.

https://youtu.be/KnorifMQe-U

 

yeah it’s not obnoxious and absolutely no drone.

 

Sounds good! Thanks for posting. Any issues with install?

 

Minor. Because of the larger diameter tubing, the heat shield where the tube goes between the frame and body needs to be bent a bit to prevent rubbing. Also, if you try to hang the muffler flat, it will cause the tube to rub that heat shield. You just have to rotate the muffler about 30 degrees and it's all good.

 

Replaced the S&B intake with the TRD intake. S&B took up space under the hood that I need for stuff.

 

Yeah. I noticed that.

 

Dual batteries???

 

Nope, air compressor. Don’t like hauling a co2 tank around inside the truck.

 

One came in handy this past weekend with as many tire issues as we had.

 

I have a 10lb CO2 Tank I carry but I’ve had a discharge inside the truck once before when I had the Tacoma. Not a fun experience.

 

That would be scary.

 

How does the ADS suspension ride with the JBA UCAs? Thinking of doing the same combo on mine. It’s a daily driver so looking for how the on-road handles as well.

 

I get hard every time I pull out of the driveway, if that says anything about how well it handles. I don’t even have sway bars installed and it’s amazing.

 

What rear springs you using?

 

Dobinsons 2.5” medium load.

 

Took the rig out to play today. Figured out where the rear wheels are rubbing. Ordered a set of duro bumps on the drive home. Hopefully that will limit the uptravel enough to stop the rubbing.

 

Just trim some more (ugh no sawzall emoji man)

 

Built a sleeping platform/storage platform over Thanksgiving week. Used 2 4x8 sheets of plywood, 1 birch and 1 standard Home Depot grade splinter infested ply. The rear platform has a slide out table/counter. Took about 4 hours to measure, cut, and build. I covered the top with an $18 roll of outdoor carpet HD had on sale. I think it came out pretty decent for my first attempt at custom carpentry. Plenty of storage underneath. My RTIC 45 fits perfectly in the single seat side when it’s folded down.

 

Added a kitchen box to the rear platform setup.

 

Can't unsee the sand that shit is evil!!!!!

Don't know where but dude that bought Eddy's buggy is from FL and apparently he's been ripping it up. Ya'll may end up seeing it down there somewhere.

 

Panhard Correction Bracket installed today.

 

Nice!!!! Not many people actually do this.

 

Yeah, my axle was about a half inch to the right with the current 2” lift and now after the bracket install, it’s now perfectly centered.